•
Remove the blade bolt by turning the bolt counter-
clockwise. Remove blade and attaching hardware:
bolt, lock washer and hardened washer.
•
Remove the Mulching plug.
•
Remove rear baffle.
•
Remove the belt cover and the stripper.
•
Remove front belt keeper.
•
Remove belt from front transmission pulley.
24 – English
MAINTENANCE
•
Remove belt from blade adapter / engine pulley.
•
Remove the old drive belt.
Replace the drive belt.
IMPORTANT! Always use genuine parts.
•
Place new belt on front transmission pulley. Be sure
the new belt is inside the tabs of the belt keeper.
•
Route the other end of the new belt through hole in
housing to the blade adapter.
•
Position the blade adapter / engine pulley on the
engine crank shaft. Be sure key in blade adapter /
engine pulley and crankshaft keyway are aligned and
that the new belt is inside the tab of the belt retainer.
•
Reinstall drive cover.
•
Reinstall rear baffle and stripper ring.
•
Reinstall the blade. See instructions in the section
"Replacing the blades".
•
Tighten spark plug.