Summary of Contents for Heatrae Sadia HSD-90103
- Page 1 Instruction Manual Wall-Mounted Body Drier HSD-90103 User Manual – Please read and retain for future reference.
-
Page 2: Safety Instruction
These notes must be read before installation These instructions are for your safety. Please read through them thoroughly before use and retain for future reference. Failure to follow them could cause injury and/or property damage. Safety Instruction This appliance is not intended for use by persons (including children) with reduced physical or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - Page 3 property deriving from failure to comply with the above recommendations, or improper use of the drier. INTRODUCTION Thank you for choosing this Body drier. This product is designed to meet the most stringent quality, performance, and safety requirements. This guide aims to improve your understanding of your new body drier by providing simple and informative instructions.
-
Page 4: Tools Required
Fig. 1b Fig. 1c 1. Drier body 2. LED 3. Micro Switch 4. Temperature Control knob 5. Wind-outing handle 6. Terminal cover 7. Blast Hose 8. Shaver socket WARNING: If installed in a bathroom, this unit must be installed by a Qualified Electrician. -
Page 5: Installation
FIXINGS SUPPLIED 2 x Wall plug 2 x Screw 1 x Hanger PARTS SUPPLIED 1x Body drier unit INSTALLATION IMPORTANT MOUNTING INSTRUCTIONS 1. When wall mounting the product, always check that there are no water, gas or electrical cables/pipes within or behind the wall. 2. -
Page 6: Technical Information
1. Follow the above points 1 - 5. 2. Connect the mains cord the terminals. Technical Information Wall-mounted Body Drier Model: HSD-90103 Rated Voltage: 220-240V~ 50Hz Rated Power: 750W Main Features: Automatic Turn On/Off Long Working: 18 Minutes will be shut off automatically Wind Temperature: 40 - 80 Shaver socket: 230V~ / 0.05A &... -
Page 7: Operation
Operation IMPORTANT Before using, check the intake grille for possible blockage by fluff, hair, etc. DRYING To start the Body drier, remove the wind-out handle from its housing. The body drier will be shut off automatically after 18 minutes working. To press the temperature controlling button to change the wind temperature. -
Page 8: Please Read The Following Carefully
electronic equipment containing more than agreed levels of lead, cadmium, mercury, exavalent chromium, polybrominated biphenyl (PBB) and polybrominated diphenyl ether (PBDE) flame retardants. Please read the following carefully ACL Group (Intl) Ltd. and/or it’s distributor has provided the parts list and assembly diagram as a reference tool only.