Floor-Tool In Use - Numatic TTB 4055/100 Owner's Instructions Manual

Pre-scrub Mode
The TTB Range has been designed to cope with a variety of floor types and different levels of soiling.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work, then scrub the area a
second time with the floor-tool lowered.

Floor-tool In Use

23
24
Breakaway Floor-tool
25
Note: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles.
Note: The machine will still reverse with the floor-tool in the lowered position,
this could possibly damage the blades. Raise the floor-tool before reversing.
Machine Operation
Refer to (Page 26) to raise and lower the floor-tool.
The clean-water / chemical mix is dispersed via the 'THRU-FEED' system.
The waste-water is then retrieved by the floor-tool.
Overlap the scrubbing path by 10cm to ensure an even clean (Fig.23).
If streaking occurs, wipe the floor-tool blades clean (Fig.24).
The floor-tool design incorporates a safety knock-off feature.
Allowing it to safely disengage from its mounting should it
become caught on an obstruction, during forward machine
movement.
To re-attach the floor-tool blade to its holder, first loosen the
retaining knobs on the floor-tool body and slide onto the
holding bracket.
Tighten retaining knobs to finger tight. (See Fig. 25)
30