Using The Interactive Stand - NordicTrack NTMC29931 User Manual

USING THE INTERACTIVE STAND

Speaker
CD Player
CD Buttons
HOW TO USE THE IONIZER
The CleanAire TM ionizer helps minimize airborne
contaminants using oppositely charged steel plates
that silently clean and circulate air without fans.
To turn on the ionizer, press the Ionizer button. To turn
off the ionizer, press the Ionizer button again. Note: If
the interactive stand is operating from the power sup-
ply, the ionizer will run until it is turned off. If the inter-
active stand is operating from batteries, the ionizer will
run for two hours and then automatically turn off. To
conserve the batteries, turn off the ionizer by pressing
the Ionizer button.
HOW TO USE NORDICTRACK WIRELESS
WORKOUT CD PROGRAMS
The interactive stand uses line-of-sight infrared tech-
nology to control your exercise equipment. To ensure
a strong signal, make sure the receiver on your exer-
cise equipment (see assembly step 4 or 5) is facing
directly toward the IR pod on the interactive stand
(see the drawing above). If your exercise equipment
does not respond to signals from the interactive stand,
see INTERACTIVE STAND TROUBLESHOOTING on
page 8.
When you use a NordicTrack Wireless Workout CD
program, a certified personal trainer will guide you
through your workout as the program controls your
exercise equipment. Note: To purchase additional
NordicTrack Wireless Workout CDs, call toll-free
1-800-735-0768.
Follow the steps below to use a NordicTrack Wireless
Workout CD program.
See the console operation instructions in the
1
user's manual for your exercise equipment
and select the iFIT.com mode.
Insert a NordicTrack Wireless Workout CD into
2
the CD player.
To open the
CD player, lift
the lid of the
CD player in
the indicated
location.
Carefully insert
a CD into the
CD player and
close the lid.
6
IR Pod
Speaker
Ionizer Button
Ionizer