Table Of Contents - Sony D-E700 Service Manual

Supplied accessories
For the area code of the model you purchased, check the upper left side
of the bar code on the package.
D-E700/E705
AC power adaptor (1)
1
Headphones (1)*
Earphones with remote control (1)*
Rechargeable batteries (2)*
Connecting cord (Phono plug × 2 ↔ stereo miniplug) (1)*
5
AC plug adaptor (1)*
3
Battery carryng case (1)*
Carrying case (1)
1
* Supplied with US model
2
* Not supplied with US model
* 3 Not supplied with US and Canadian models
4
* Not supplied with AEP, French, East European, UK and Tourist
models
* 5 Supplied with Tourist, E33, E13 and Chinese models
D-E800/E805
AC power adaptor (1)
Headphones with remote control (1)*
Earphones with remote control (1)*
Rechargeable batteries (2)
Connecting cord (Phono plug × 2 ↔ stereo miniplug) (1)*
4
AC plug adaptor (1)*
Battery carryng case (1)
Carrying case (1)
1
* Supplied with US model
2
* Not supplied with US model
* 3 Not supplied with AEP, UK, French and Tourist models
4
* Supplied with Tourist, E33, E13 and Chinese models
Design and specifications are subject to change without notice.
• Abbreviation
E13: 220 - 230 V AC area
E33: 100 - 240 V AC area
E92: 120 V AC area
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK ! OR DOTTED
LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
LISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE !
SUR LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE
DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ
DE FONCTIONNEMENT. NE REMPLACER CES COM-
POSANTS QUE PAR DES PIÈCES SONY DONT LES
NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
2
3
4
1
2
3

TABLE OF CONTENTS

1. GENERAL
................................................................... 3
2. SERVICE NOTE
3. DISASSEMBLY
4. SERVICE MODE
5. ELECTRICAL ADJUSTMENTS
6. DIAGRAMS
6-1. Block Diagram ................................................................ 12
6-2. Printed Wiring Boards ..................................................... 14
6-3. Schematic Diagram ......................................................... 17
6-4. IC Pin Function Description ........................................... 29
7. EXPLODED VIEWS
8. ELECTRICAL PARTS LIST
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
This appliance is classified as a CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT MARKING is located on
the rear exterior.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
- 2 -
........................................................ 6
......................................................... 7
...................................................... 8
......................... 9
................................................ 31
............................... 34