Table of Contents
Advertisement
APPENDIX D: TROUBLESHOOTING
"How do I properly set the input sensitivity on my amplifier"
"My amplifier doesn't turn on"
"I get a distorted / attenuated sound coming out of the speaker(s)"
"My amplifier's output fluctuates when I tap on it or hit a bump"
14
Please refer to Appendix A (page 12) to set the input sensitivity for
maximum, low-distortion output.
Check the fuse, not just visually, but with a continuity meter. It is
possible for a fuse to have poor internal connections that
cannot be found by visual inspection. It is best to take the
fuse out of the holder for testing. If no problem is found with
the fuse, inspect the fuse-holder.
Check the integrity of the connections made to each of the
"+12VDC", "Ground", and "Remote" terminals. Ensure
that no wire insulation is pinched by the terminal set screw
and that each connection is tight.
Check to make sure there is +12V at the "Remote" connection of the
amplifier. In some cases, the turn-on lead from the source unit
is insufficient to turn on multiple devices and the use of a relay
is required. To test for this problem, jump the "+12VDC" wire
to the "Remote" terminal to see if the amplifier turns on. If this
does not work, proceed to the next step.
Check the speaker wires for a possible short, either between the
positive and negative leads or between either speaker lead
and the vehicle's chassis ground. If a short is present, you
will experience distorted and/or attenuated output. The
"Protect" light will illuminate in this situation. It may be
helpful to disconnect the speaker wires from the amplifier
and use a different set of wires connected to a test speaker.
Check the nominal load impedance to verify that of the amplifier is
driving a load equal to or greater than 2 ohms.
Check the input signal and input signal cables to make sure signal
is present at the "Amplifier Inputs" and the cables are not
pinched or loose. It may be helpful to try a different set of
cables and/or a different signal source to be sure.
Check the connections to the amplifier. Make sure that the
insulation for all wires has been stripped back far enough to
allow a good contact area inside the terminal block.
Check the input connectors to ensure that they all are making good
contact with the input jacks on the amplifier.
JL AUDIO M1700
Advertisement
Table of Contents
