Using Your Removable Handheld Steamer With Direct Steam Nozzle; Using Your Removable Handheld Steamer With Accessory Hose - Shark S3901UKE Owner's Manual

Using Your Removable Handheld Steamer with Direct Steam Nozzle

Cleaning Tip: The Direct Steam Nozzle creates direct steam spray to clean and sanitise hard to reach nooks &
crannies and other places where germs may build up. Use the Direct Steam Nozzle to loosen and dislodge compact
dirt often found in corner and tight places where traditional methods and cleaning tools tend to push dirt into, making
it tough to reach and clean. Spray direct steam and wipe clean with a wet cloth or paper towel.
fig. 16
fig. 17
FOR SPOT CLEANING AND STEAMING
2 Remove the Direct Stream Nozzle from the storage
clip on the mop handle and attach it by pressing the
nozzle onto the Handheld Steamer until it clicks into
place. (fig. 16, fig. 17)
3
The Handheld Steamer is automatically set to
SCRUB mode. Squeeze the steam trigger to activate
steam. To change modes press the ON/STEAM
SETTING button to select either DUST, MOP or
SCRUB mode. You can change the steam mode
while the Handheld Steamer is in standby or in use.
Once the selected setting indicator light has turned
blue, hold down the steam trigger to start steaming.
(fig. 18)
For effective cleaning, hold the steam output nozzle
2.5 - 5 cm away from the surface you're cleaning.
13 FREEPHONE 0800 862 0453
fig. 18
CAUTION: Do not press the steam trigger until the
Direct Steam Nozzle is snapped into the main nozzle
of your Handheld Steamer.
4 To remove the Direct Steam Nozzle, press and hold
down the Handheld Release Buttons. Then slide out
the Direct Steam Nozzle using the grip.
CAUTION: Do not press the steam trigger while
removing the Direct Steam Nozzle. Avoid touching
the tip of the Direct Steam Nozzle, as this will be
very hot after steaming.
NOTE: The Handheld Steamer may continue to emit
steam for a few seconds after the trigger is released.
This is normal, and the steaming will eventually
come to a stop.

Using Your Removable Handheld Steamer with Accessory Hose

fig. 19
1
To use the Accessory Hose, first attach the
Accessory Hose to the Handheld Steamer by
snapping the Accessory Hose into the main nozzle.
(fig. 19)
2 Select the desired cleaning tool for use. Follow the
cleaning tool sub-assembly instructions for the
selected tool.
3 To remove the Accessory Hose, press and hold
down the Handheld Release Buttons. Then slide out
the Accessory Hose using the grip. (fig. 20)
fig. 20
CAUTION: Do not press the steam trigger while
attaching or removing the Accessory Hose.
CAUTION: Do not use the Accessory Hose without
cleaning tools attached.
www.sharkclean.eu 14