Table of Contents
Advertisement
2
Making Measurements
Measuring Resistance, Conductance, and Testing Continuity
C A U T I O N
40
Disconnect circuit power and discharge all high-voltage capacitors
before measuring resistance or conductance, or testing circuit
continuity, to avoid damaging the multimeter or the device under test.
1 Set the rotary switch to
resistance measurement.
2 Connect the red and black test leads to input terminals
Ω (red) and COM (black) respectively (see
page 41).
3 Probe the test points (by shunting the resistor) and read
the display.
4 Press
to scroll through audible continuity test
(
or
, depending on Setup configuration),
conductance measurement (
measurement (
Figure 2- 8
on page 42.
. The default function is
), and resistance
,
, or
) as shown in
U1253A User's and Service Guide
Figure 2- 7
on
Advertisement
Table of Contents
