Ipv6 - ZyXEL Communications LTE3311 series User Manual

6.6 IPv6

Use this screen to configure the LTE3311's IPv6 settings. Click Network > WAN > IPv6 from the
Configuration menu.
Figure 32 Network > WAN > IPv6
The following table describes the labels in this screen.
Table 16 Network > WAN > IPv6
LABEL
IPv6
IPv6 Connection
DNS Setting
Primary DNS Address
Secondary DNS
Address
LAN IPv6 Address
LAN IPv6 Link-Local
Address
Autoconfiguration
Autoconfiguration Type Select Stateless if you want the LTE3311 interface to automatically generate a link-
Chapter 6 WAN
DESCRIPTION
Select Enable to allow the LTE3311 to run IPv6. Otherwise, select Disable.
Select DHCPv6 if you want to obtain an IPv6 address from a DHCPv6 server.
Select Obtain DNS Server address Automatically to have the LTE3311 get the
IPv6 DNS server addresses from the ISP automatically.
Select Use the following DNS address to have the LTE3311 use the IPv6 DNS
server addresses you configure manually.
Enter the first IPv6 DNS server address assigned by the ISP.
Enter the second IPv6 DNS server address assigned by the ISP.
Enter the IPv6 address for the LTE3311 LAN interface in this field.
This shows the IPv6 Link-local address in the LAN side. This is used by LTE3311 when
communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Click Enable if you want the devices on your local area network to obtain network
address that are not managed by a DHCPv6 server. Otherwise, select Disable.
local address via stateless autoconfiguration.
Select Stateful (DHCPv6) when the devices connected to your LAN needs to have
their TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
LTE3311 Series User's Guide
62