Nokia 6680 User Manual page 90

R1105_en.book Page 90 Monday, February 7, 2005 1:31 PM
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
Access point name (for packet data only)—The access
point name is needed to establish a connection to the
packet data and UMTS networks. You obtain the access
point name from your network operator or service
provider.
Tip! See also 'Receive MMS and e-mail settings', p.
47, 'E-mail', p. 54, and 'Access the Web', p. 60.
User name—The user name may be needed to make a data
connection, and is usually provided by the service
provider. The user name is often case-sensitive.
Prompt password—If you must enter a new password
every time you log in to a server, or if you do not want to
save your password in the phone, choose Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service
provider. The password is often case-sensitive.
Authentication—Select Normal
Homepage—Depending on what you are setting up, write
the Web address or the address of the multimedia
messaging centre.
Select Options > Advanced settings
following settings:
90
Network type—Select the Internet protocol type to use:
IPv4 settings
Phone IP address—Enter the IP address of your phone.
Name servers—In
of the primary DNS server. In
the IP address of the secondary DNS server. Contact your
Internet service provider to obtain these addresses.
Glossary: The domain name service (DNS) is an
Internet service that translates domain names such as
www.nokia.com
Proxy serv. address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data
are in a network that supports packet data, the phone
registers to the packet data network. Also, starting an
or Secure.
active packet data connection is quicker (for example, to
send and receive e-mail). If you select
phone uses a packet data connection only if you start an
application or action that needs it. If there is no packet
to change the
data coverage and you select
periodically tries to establish a packet data connection.
or IPv6 settings.
Primary name server:, enter the IP address
Second. name server:, enter
into IP addresses like 192.100.124.195.
conn.—If you select When available and you
When needed, the
When available, the phone