Table of Contents
Advertisement
106
TROUBLESHOOTING
Problem
TFT Display -
Weak signal from the
Wi-Fi
connected AP
disconnection.
TFT Display -
System Error and No Answer
Error popup is
occurred.
TFT Display -
Change of touch panel set value
Touch do not
by environmental factor
work.
TFT Display -
System overload
Auto Reset.
Refrigerator or
Refrigerator was recently
Freezer section is
installed.
too warm.
Air vents are blocked.
Doors are opened often or for
long periods of time.
Unit is installed in a hot location. The refrigerator should not be operated in
A large amount of food or
hot food was added to either
compartment.
Doors not closed correctly.
Temperature control is not set
correctly.
Defrost cycle has recently
completed.
Possible Causes
Solutions
Move the AP installed at home closer to the
refrigerator, and place the AP at the height close
to the height of the refrigerator. If you cannot
move the AP, install a repeater to raise the
wireless signal strength.
'Press 'Force' button to close the popup window,
and retry the corresponding operation. If it keeps
occurring, open the right side door, and turn off
and on the TFT Reset switch at the top.
After the screen becomes power saving state(Off
state), touch the screen again. If no touch sense
occurs again, open the right side door, and turn
off and on the TFT Reset switch at the top.
It is turning on again for stabilization of the
system, so it is not a disorder. The existing
values remain as they are.
It may take up to 24 hours for each compartment
to reach the desired temperature.
Rearrange items to allow air to flow throughout
the compartment. Refer to the Airflow diagram in
the Using Your Refrigerator section.
When the doors are opened often or for long
periods of time, warm, humid air enters the
compartment. This raises the temperature and
moisture level within the compartment. To lessen
the effect, reduce the frequency and duration of
door openings.
temperatures above 110°F.
Adding food warms the compartment requiring
the cooling system to run. Allowing hot food to
cool to room temperature before putting it in the
refrigerator will reduce this effect.
See the Doors will not close correctly or pop open
section in Parts & Features Troubleshooting.
If the temperature is too warm, adjust the
control one increment at a time and wait for the
temperature to stabilize. Refer to the Setting the
Controls section for more information.
During the defrost cycle, the temperature of each
compartment may raise slightly and condensation
may form on the back wall. Wait 30 minutes
and confirm the proper temperature has been
restored once the defrost cycle has completed.
Advertisement
Table of Contents
