Hinge Caps; Replacing The Display Assembly; Removing The Hinge Caps - Dell Inspiron 1320 Service Manual

1 screws (6)
3 camera cable connector
11. Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from the routing guides.
12. Lift the display assembly off the computer.

Replacing the Display Assembly

1. Place the display assembly in position and replace the six screws (three on each side) of the display assembly.
2. Route the Mini-Card antenna cables through the routing guides.
3. Connect the display cable and the camera cable to their respective system board connectors.
4. Replace the palm rest (see
5. Replace the hard drive (see
6. Replace the keyboard (see
7. Replace the center control cover (see
8. Connect the antenna cables to the Mini-Card.
9. Replace the module cover (see
10. Replace the battery (see Replacing the
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Hinge Caps

Removing the Hinge Caps

1. Follow the instructions in Before You
2 display cable connector
Replacing the Palm Rest).
Replacing the Hard Drive).
Replacing the Keyboard).
Replacing the Center Control
Replacing the Module Cover).
Battery).
Begin.
Cover).