Advertisement
Quick Links
Advertisement
Related Manuals for Shark MV2010UKJR
Summary of Contents for Shark MV2010UKJR
- Page 1 VAC-THEN-STEAM™ MV2010UKJR OWNER’S GUIDE...
- Page 2 IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS For Household Use Only 9. DO NOT handle plug or appliance WHEN USING YOUR SHARK VAC- ® with wet hands or operate appliance THEN-STEAM™, BASIC SAFETY without shoes. PRECAUTIONS SHOULD ALWAYS 10. DO NOT pull or carry by power cord,...
- Page 3 19. Carefully remove the microfibre 34. DO NOT run the cleaning unit over pad immediately after you have large-sized objects. unplugged and allowed the 35. DO NOT pick up hard or sharp appliance to cool. objects such as glass, nails, screws 20.
- Page 4 Only this method creates and delivers 100°C steam that is effective enough to clean and sanitise all your hard floor surfaces. The Shark ® Vac-Then-Steam™ can help you achieve a truly clean and healthy environment for you and your family.
-
Page 5: Table Of Contents
Contents Getting Started: Assembly ..........2 Getting Started: Mode Controls ........4 Vacuum Mode .................5 Steam Mode ................8 Maintaining Your Vac-Then-Steam™ ......12 Troubleshooting Guide ............14 www.sharkclean.co.uk... -
Page 6: Getting Started: Assembly
Getting Started: Assembly When assembling your Vac-Then-Steam™ there may be a little water in or around the water tank. This is because we quality test all our Shark products before distributing them, so you get a quality Shark Vac-Then-Steam™. ®... - Page 7 ASSEMBLY Wrap cord around cord holders and Slide the Telescopic Handle into the secure plug to cord. cleaning unit until it locks into place. NOTE: The Vac-Then-Steam™, is Once in position, you never have to a complete bare-floor cleaning remove the handle. and sanitising system.
-
Page 8: Getting Started: Mode Controls
Getting Started: Vacuum and Steam Panel STEAM MODE: The Vac-Then-Steam™ has two operating modes: VACUUM MODE: DO NOT USE STEAM PAD AND FRAME IN VACUUM MODE OPERATING IN STEAM MODE: Attach steam pad and frame. Steam mode will not work if the pad and frame are NOT attached. -
Page 9: Vacuum Mode
Vacuum Mode After inserting the telescopic handle, your cleaning system is vacuum-ready. Begin vacuuming your hard-surface floors by tilting the cleaning unit back and pressing the vacuum power button. USING VACUUM MODE Place your foot lightly on the top Pull and twist the quick release cord of the cleaning unit base. - Page 10 Vacuum Mode STORAGE IMPORTANT: Place your foot lightly on the top of Always carry the base. Tilt cleaning unit into the the Vac-Then- upright position. Steam™ by the cleaning unit Turn OFF “O” the vacuum power collar; rather button and unplug the unit. than by the Wrap cord around cord holders and handle.
- Page 11 EMPTYING THE DUST CUP EMPTYING THE CONE FILTER EMPTYING THE DUST CUP Tap filter canister gently over trash Press the dust cup latch at the receptacle to empty debris from the bottom of the canister upward. Pull conical filter. the dust cup assembly out and down. Reattach the filter frame.
-
Page 12: Steam Mode
Steam Mode MAGNETIC CONNECTIONS ASSEMBLY Place the cleaning unit onto the Attach a steam pad onto the bottom Steam Frame. THE UNIT MUST BE of the steam frame, matching the UPRIGHT. hook and loop fasteners. IMPORTANT: steam frame and pad Place the steam frame/pad assembly must be attached to the cleaning unit on the floor with the magnetic... - Page 13 Do not use chemicals or detergents in your Vac-Then-Steam™. You only need water to achieve super-heated, sanitising steam. FILLING THE WATER TANK NOTE: If you live in a hard water Keep the cleaning unit in the upright area, we recommend using distilled water in your Vac-Then-Steam™.
- Page 14 Steam Mode STEAM CLEANING Place your foot lightly on the top of Plug in the cleaning unit. Slide the the base. TILT HANDLE BACK TO toggle switch to expose the steam ACTIVATE STEAM PUMP. power button. Push handle upright to stop steam. Press the steam power button to the NOTE: Check water level and fill ON “I”...
- Page 15 40° STORAGE CARE OF YOUR MICROFIBRE Unplug and turn the unit OFF “O”. CLEANING PAD Press your foot on the steam frame. Wash pads in warm water. Wash Separate steam pad from steam separately from other laundry. Only frame. use liquid detergent (no powder detergent).
-
Page 16: Maintaining Your Vac-Then-Steam
Maintaining Your Vac-Then-Steam™ Replacement filter sets have been provided with your product. Use one of the replacement filter sets when another set is drying. Thin Filter Thick Filter CARE OF YOUR DUST CUP FILTERS RECOMMENDED MAINTENANCE SCHEDULE: Using only water, Unplug and turn OFF “O”... - Page 17 A replacement post-motor filter has been provided with your product. Use the replacement filter while the other is drying. POST-MOTOR FILTER Twist the Shark logo knob clockwise ® Remove the Shark logo sticker from ® and replace the two screws to secure...
-
Page 18: Troubleshooting Guide
Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS Your Vac-Then-Steam™ should be securely plugged into a The Vac-Then- 220-240V AC electrical outlet only. Steam™ will not turn Check your fuse or breaker. Switch Steam or Vacuum Power button to the ON “I” position. - Page 19 This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of electrical and electronic equipment (WEEE). This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its revisions, as well as Low Voltage Directive (LVD) 2006/95/EC and its revisions. This marking indicates that this product should not be disposed with other household wastes throughout the EU.
- Page 20 South Shields NE33 5SP info@JMLgroup.co.uk Freephone 0800 781 7831 www.sharkclean.co.uk Registered address: JML House, NW5 3EG Technical Details Model number: MV2010UKJR 11 Input: Vacuum: 400 Watts Steam: 1550 Watts Main unit voltage: 220-240V., 50 Hz. COPYRIGHT© EURO-PRO OPERATING LLC 2010 PRINTED IN CHINA MV2010UKJR.E.101021...