Remove The Back Cover; Remove The Battery; Install The Mmc Card - Nokia 6256i User Manual

■ Battery
Note: Before removing the cover, always switch off the power and
disconnect the charger and any other device.
Avoid touching electronic components while changing the covers. Always store
and use the device with the covers attached.

Remove the back cover

1. With the back of the phone facing you,
push down on the back cover.
2. Slide the back cover toward the bottom of
the phone and remove.

Remove the battery

After you have removed the back cover, insert
your finger into the finger grip, and lift the
battery from its compartment.
UIM (CDMA SIM) card slot
Your phone has a UIM card slot built into the mechanics. However, the UIM is not
functional in this phone model. Avoid placing anything into the UIM card slot.

Install the MMC card

Before installing the MMC card, always
make sure that the phone is switched
off and that you have removed the cover
and battery.
Open the MMC holder by lifting the
latch (1) and lifting the holder up (2).
15
Set up your phone
Copyright © 2005 Nokia