Polaris UTV 2x4 Series 11 Owner's Manual page 93

MAINTENANCE AND LUBRICATION
Cleaning Your Polaris UTV
Keeping your vehicle clean will not only improve its appearance but it
can also extend the life of various components. With a few
precautions, your vehicle can be cleaned much like an automobile.
The best and safest way to clean your vehicle is with a garden hose and
a pail of mild soap and water. Use a professional type washing mitten,
cleaning the upper body first and the lower parts last. Rinse with water
frequently and dry with a chamois to prevent water spots. NOTE: If
warning labels are damaged, contact your Polaris dealer for free
replacement.
If a high pressure type car wash system is used, extreme care must be
taken to avoid water damage to the wheel bearings, transmission seals,
body panels, brakes, headlights and warning labels. Many expensive
repair bills can result from using high pressure detergent systems.
NOTE: If a high pressure car wash is used, grease all zerk fittings
immediately after washing. Also run the vehicle to evaporate any
water that may have entered the engine or exhaust system.
Storage
If your vehicle is to be placed in extended or off season storage, the
following steps should be taken to preserve its condition.
1. Perform all necessary repairs and thoroughly clean the vehicle.
2. Remove the spark plug and pour approximately one ounce of
Premium 4 oil into the cylinder. Operate the starter for a few
seconds and reinstall the spark plug.
3. Remove the battery. Store it in a cool, dry place out of the sun.
4. Lubricate suspension pivot points, lower steering post and rear axle
fittings.
5. Drain the engine side cover.
6. Block the vehicle so all tires are suspended off the ground.
7. Spray oil on all unpainted metal surfaces to prevent rusting. Avoid
getting oil on rubber parts or in the brakes.
8. Lubricate all cables.
9. Tie a plastic bag over the exhaust pipe and air cleaner inlet to
prevent moisture or small animals from entering.
10. Cover the vehicle with a canvas cover. Do not use plastic or coated
materials since they do not allow ventilation for the vehicle.
91