GE AEN10 Series Owner's Manual And Installation Instructions page 11

INSTALL THE CASE IN THE WINDOW
8
Open the window and mark the centerline of
A
the window sill.
Carefully place the case on the window stool
B
and align the center mark on the bottom front
with the centerline of the sill.
Pull the window down behind the top mounting
C
rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is
restricted.
Select the position that will place the sill
D
supports near the outermost point on the sill.
Place the short side of the sill supports, on the
case bottom, toward the window. Attach the sill
supports to the case track hole in relation to the
selected position using 2 Type B screws in each
support.
CAUTION:
conditioner in a window if the bolts do not contact
the window sill.
Adjust the bolt and the nut in each support so
E
that the case is installed with a slight tilt to the
outside. Use a level; no more than 1/2 bubble
will be the correct case slant to the outside.
CAUTION:
not contact the window sill or if you have a window
without a sill you must order accessory kit RAK87 to
properly install this air conditioner. Call 800.626.2002
or visit GEAppliances.com.
Installation Instructions
Do not install this air
Long side of
sill supports
OUTSIDE
If the sill support bolts do
INSTALL THE CASE IN THE WINDOW
8
(CONT.)
F Secure the case to the window sill by using 3
Type D screws.
Pull the accordion panels to each window sash
G
track. Attach them on each side to the window
sash and the window sill using
4 Type C screws.
11