Sony KV-32XBR200 Service Manual page 27

更多难得资料请到江南家电维修论坛免费下载！
http://bbs.520101.com
V. SIZE ADJUSTMENT ( VSIZ)
1. Input a monoscope signal.
2. Set to Service adjustment mode.
3. Select VSIZ with and
4. Adjust with and for the best vertical size.
5. Write into the memory by pressing
V. SIZE
V. POSITION ADJUSTMENT (VPOS)
1.Input a monoscope signal.
2.Set to Service adjustment Mode.
3.Select VPOS with and
4.Adjust with and for the best vertical center.
5.Write into the memory by pressing
V. POSITION
H. POSITION ADJUSTMENT (HPOS)
Perform this adjustment after H. FREQUENCY ADJ. (HFRE).
1. Input a monoscope signal.
2. Set the Service adjustment Mode.
3. Select HPOS with and
4. Adjust with and for the best horizontal center.
5. Write into the memory by pressing
H. POSITION
V LINEARITY (VLIN), V CORRECTION (VSCO), PIN AMP
(PAMP) AND PIN PHASE (PPHA) ADJUSTMENTS
1. Input a cross-hatch signal.
2. Set to Service adjustment Mode.
3. Select VLIN, VSCO, PAMP, and PPHA with
4. Adjust with and for the best picture.
5. Write the memory by Pressing
V LINEARITY(VLIN)
.
then
.
then .
.
then .
and .
then .
VS CORRECTION (VSCO)
PIN AMP (PAMP)
.
PIN PHASE (PPHA)
V ANGLE (VANG), V BOW (VBOW), UPPER PIN (UPIN)
AND LOW PIN (LPIN) ADJUSTMENTS
1. Input a cross hatch signal.
2. Set to Service adjustment Mode.
3. Select VVANG, VBOW, UPIN, and LPIN with
4. Adjust with and
5. Write the memory by Pressing
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
A BOARD
Y/B–Y/R–Y LEVEL ADJUSTMENT
1. Set: VIDEO mode = STANDARD
PICTURE = 100%
COLOR = 50%
HUE = 50%
2. Set a select Video 4 (DVD) Mode.
3. Input a 75% color bar signal.
— 27 —
KV-32XBR200/KV-36XBR200
and
for the best picture.
then
.
.