Philips SRP4004/86 User Manual page 6

3
4
5
• I f a key does not function as expected, press and hold it
6
• I f you wish to restart setup, you can start again from
6
SRP4004_86_Manual.indd 6
Look up the brand of your
TV in the brandlist at the
back of this user manual.
A four-digit code is shown
for each brand.
Use the digit keys to enter
the code for your brand
(e.g. Philips,
• I f the red Setup LED
turns off, an invalid code
was entered. In this case,
try again.
Aim the remote control at
the TV. Press and hold the
key and immediately
release it when the TV
switches off (standby).
• This step normally
takes between 5 and 60 seconds. In extreme
circumstances this step can take up to 15 minutes.
Turn ON the TV and check
if all keys that you need for
operating your TV are
working. Try, for example, if
the - CH + and digit keys
function properly.
and immediatley release it as soon as it works. For more
information, see chapter 2.3.2.
Press the device
selection key twice to save
your settings and exit setup
mode.
• When no key is pressed
for 5 minutes or more,
the remote control will
exit setup mode, automatically saving all your settings.
Note
the beginning at any time.
EN
).
5-60 SEC.
5 - 60 sec.
2 x
28-05-09 18:17