Mechanism Parts - Toshiba SD-110EB Service Manual

1-2-3. Front PC Board
1. Remove the front panel. (Refer to item 1-1-4.)
2. Remove six screws (1) and remove the front display
PC board (2)
3. Remove two screws (3) and remove the power switch
PC board (4).
Power SW Screws (3)
PC board (4)
Fig. 2-1-11
1-2-4. Output-RGB PC Board
1. Remove two screws (1).
2. Remove the flexible cable (2).
3. Remove the connector (3) and remove the Output-
RGB PC board (4).
Connector (3)
Fig. 2-1-12
Front display
PC board (2)
Screws (1)
Output-RGB
PC board (4)
Flexible
cable (2)
Screws (1)

1-3. Mechanism Parts

1-3-1. Mechanism Chassis Assembly
Note:
• When removing the mechanism chassis assembly (3),
be sure to short-circuit the laser diode output land
before removing the connector and the flexible cables.
After replacing, open the land as it was after inserting
the connector and flexible cables.
1. Remove the tray. (Refer to items 1-1-3 and 1-1-4.)
2. Remove three flexible cables (1).
3. Remove four screws (2) and remove the mechanism
chassis assembly (3).
Screws (2)
Mechanism
chassis assembly (3)
Fig. 2-1-13
Type A
Pickup head
Laser diode
output land
Type B
Flexible
Pickup head
cables (1)
Laser diode
output land