Advertisement
Names of the Components
Flash stand
Light diffusing panel / Fill-in reflector
Flash head
AF-assist light / wireless flash sensor
Lock ring
Mounting foot
Hotshoe contacts
X - Terminal
Pilot lamp (Test flash button)
Battery compartment door
Power switch (Press button)
Mode select button / indicator
(TTL → Manual → SD → SF → Wireless)
Flash power leveel indication lamp (6 LEDs)
Flash power level select button
Accessories: Flash stand, Pouch
Mounting Di622 Mark II on the camera
Twist the lock ring anti-clockwise to
loosen it as shown in the picture.
Slide the mounting foot of Di622 Mark
II into the hotshoe of camera.
Twist the lock ring clockwise to tighten
it.
Removing Di622 Mark II from the camera
Loosen the lock ring and slide the mounting foot of Di622 Mark II off
the hotshoe of camera.
NOTE
Before mounting or removing Di622 Mark II into or from the camera,
make sure to turn off the power switch of both Di622 Mark II and the
camera.
Basic Operation
Inserting batteries
Open the battery compartment door and
insert 4 x size AA batteries as shown by
the picture.
Make sure the + and - battery contacts are
correctly inserted at the battery compart-
ment.
Close the battery compartment door and
slide it back in place.
NOTE
Wrong inswrtion or using different size batteries may result damage on the
flash unit.
It is recommended to use all 4 batteries in same brand and type, and
replce them all att he same time.
Turn on the flash unit
Press the On/Off switch and Pilot
lamp turns red showing the unit is
turned on.
In a few seconds, the Pilot lamp
turns green. Di622 Mark II is
For a test flash, press the Pilot lamp. When using
the test flash as an open flash, please note that the
To turn off the flash unit manually, press the On/Off
Di622 Mark II has energy saving double power off function
To save battery energy, the power is automatically turned off
(switch to stand-by mode), both in TTL mode & Manual Power
mode, in about 2 minutes of idle use.
While Di622 Mark II is in the stand-by mode a Pilot lamp blinks
every 2 seconds showing the flash unit is in stand-by mode.
To turn on Di622 Mark II again, press the camera's shutter button
halfway or press any button of the flash unit.
In case Di622 Mark II is not in use over 30 minutes, the unit is
completely turned off and shut out the current leakage from the
batteries.
To turn on Di622 Mark II again, take the first step of turning the
flash unit on.
In case of using Di622 Mark II in slave or remote mode, Di622
Mark II will not go into the stand-by mode. It will however
automatically turn off when not used over 60 minutes.
Ch1 Group A
D
F
Advertisement
