Standard Signal Mode Table - Seiki SM28UTR User Manual

Specifications

Standard Signal Mode Table

• This product can be set to only one resolution for each screen size to obtain the optimum picture quality due to the nature of the panel.
Therefore, a resolution other than the specified resolution may degrade the picture quality. To avoid this, it is recommended that you
select the optimum resolution specified for the screen size of your product.
• Check the frequency when you exchange a CDT monitor (connected to a PC) for an LED monitor. If the LED monitor does not support
85Hz, change the vertical frequency to 60Hz using the CDT monitor before you exchange it with the LED monitor.
Model Name
Synchronization
Resolution
If a signal that belongs to the following standard signal modes is transmitted from your PC, the screen will automatically be adjusted. If
the signal transmitted from the PC does not belong to the standard signal modes, the screen may be blank even though the power LED
turns on. In such a case, change the settings according to the following table by referring to the graphics card user manual.
Horizontal Frequency
The time required to scan a single line from the left to the right side of the screen is called a horizontal cycle. The reciprocal number
of a horizontal cycle is called horizontal frequency. Horizontal frequency is measured in kHz.
Vertical Frequency
Repeating the same picture dozens of times per second allows you to view natural pictures. The repeat frequency is called "vertical
frequency" or "refresh rate" and is indicated in Hz.
Horizontal Frequency
Vertical Frequency
Optimum Resolution
Maximum Resolution
SM28UTR
30 ~ 134 kHz (DisplayPort)
30 ~ 90 kHz (HDMI)
56 ~ 75 Hz (DisplayPort)
24 ~ 75 Hz (HDMI)
3840 x 2160 @ 60Hz (DisplayPort)
60HZ(Only HDMI 1 )
3840 x 2160 @ 60Hz (DisplayPort)
60HZ(Only HDMI 1 )
29
Specifications