Checking Jumper Settings - ECS H61H2-I3 User Manual

2-3. Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.
1. To avoid the system instability after clearing CMOS, we recommend users
to enter the main BIOS setting page to "Load Default Settings" and then
"Save and Exit Setup".
2. Make sure the power supply provides enough 5VSB voltage before se-
lecting the 5VSB function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto 2-
3 pin rather than 1-2 pin as default if you want to wake up the computer
by USB/PS2 KB/Mouse.
10
H61H2-I3 USER MANUAL