Philips 109P2 CM25 GSIII Service Manual page 12

12 109P2 GS3 CM25
9
Go to cover page
How to change the Year, Week & Serial
number of Monitor [for PHILIPS(PCEC)
models]
Use arrow keys to highlight "Barcode format", under the Setup menu,

press "Enter".
Bring up : Barcode example
‚
Barcode format
----------------------------------------------------------
continued: Barcode example
ƒ
Barcode format
----------------------------------------------------------
Manufacture Year
Manufacture Week
Serial No.
Serial No. ASCII
================================
EDID [16] Week
EDID [17] Year
EDID [12..15]
EDID [77 -89]
data correct ? (Y/N) Y
There is a description at the lower of the screen for Barcode format as
below.
Barcode format : Y,W,S,X,- (year,week,s/no,ignore,fixed)
Y stands for "year".
W stands for "week".
S stands for "s/no (serial number)".
X stands for "ignore". Allow user to fill in any 'character' or 'numeric'.
- stands for "fixed". User have to fill in Special 'character' or 'numeric'
for "AutoScan" if user fill in '-' at "Barcode format :".
Use arrow keys to highlight "Auto Scan" under the R/W menu, press
„
"Enter".
Bring up: Auto Scan
…
Serial Number
Year Code
Week Code
*
don't care
(If monitor is not at Factory Mode, access Factory Mode at
this moment.)
Fill in "Barcode data (for instance: 003412345678)" beside AutoScan,
†
press "Enter".
After 10 seconds around, bring up:
File R/W
Write EDID to EEPROM
Read From EEPROM
Edit EDID Code
Auto Scan
Factory writing ...100% (58) (f8) (7f) (12).
Back
DDC Instructions (Continued)
: 003412345678
: YYWWSSSSSSSS
: 003412345678
: YYWWSSSSSSSS
press "space"
: 1999
: 34
: 12345678
: _ TY _ _ 12345678
TY
: 22
: 09 [Year-1990]
: 00bc614e
: TY
year, week, serial
¬
number can be
changed.
Setup Quit
*
¬ Fill in 993412345678, press "Enter"
Fill in YYWWSSSSSSSS, press "Enter"
¬
Factory code for each site is as below.
Brazil H C (48h,43h)
Chungli T Y (54h,59h)
Delta G K(47h,4Bh)
Juarez Y A(59h,41h)
Shenzshen C X(43h,58h)
Suzhou BZ (42h,5Ah)
Szombathely HD (48h,44h)
Fill in "Y", don't press "Enter"
¬
Press "ESC" "ESC", return to R/W menu.
‡
Select "Edit EDID code", press "Enter".
ˆ
Verify "ID Serial No.".............
‰
Turn off monitor, then turn on monitor again.
Press OSD button, select "MONITOR STATUS", press OSD button

again.
Verify "SERIALNO".
‚
(Leave OSD function).
Use arrow keys to highlight "QUIT", press "Enter".
ƒ
Forward