Philips HQ7350 User Manual
Hide thumbs
Also See for HQ7350:
- Manual (96 pages) ,
- Instructions manual (182 pages) ,
- User manual (180 pages)
Related Manuals for Philips HQ7350
Summary of Contents for Philips HQ7350
- Page 1 ENGLISH 4...
- Page 2 ENGLISH Introduction Congratulations on your purchase and welcome Philips offers, register your product at www.philips. com/welcome. Important Read this user manual carefully before you use the appliance and save it for future reference. This appliance is not intended for use by persons...
- Page 3 Noise level: Lc = 59dB(A) This Philips appliance complies with all standards properly and according to the instructions in this user manual, the appliance is safe to use based on...
- Page 4 ENGLISH Charging When you start charging the empty shaver, the charging light goes on. Battery fully charged When the battery is fully charged, the charging When you unplug the shaver, the charging light goes out. After charging, the shaver has a cordless shaving time of up to 35 minutes.
- Page 5 Shaving on a dry face gives the best results. Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Press the on/off button once to switch off the shaver.
- Page 6 ENGLISH Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Note: Water may leak from the socket at the bottom of the appliance when you rinse it. This is normal and not dangerous.
- Page 7 ENGLISH Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). Clean the cutters and guards with the brush supplied. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored.
- Page 8 Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philips shaving heads only. Note: Do not mix up the cutters and the guards to guarantee optimal shaving performance. Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver.
- Page 9 If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way.
- Page 10 ENGLISH Let the shaver run until it stops, undo the two screws in the hair chamber and remove it. Undo the two screws at the back of the shaver and remove the back panel of the housing. Remove the side panels by pulling them off the sealed power unit.
- Page 11 ENGLISH If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Consumer is no Consumer Care Centre in your country, go to your local Philips dealer. The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear.
- Page 12 ENGLISH The shaving unit has come off the shaver. The shaving unit has not been placed correctly. If the shaving unit becomes detached from the shaver, you can easily put it back by inserting the hinge into the slot in the rim of the hair chamber and pushing it home until it locks into place (‘click’).
- Page 20 HQ110 Philips.
- Page 22 www.philips.com...