Table of Contents
Advertisement
After the 3 - 2 - 1 countdown, 0:01
is displayed, close the door of the
product and wait for the draining
process complete. Draining is
completed in 2 minutes and the
machine gives an audible warning
when it is completed.
C
You can select and start a
new programme following
the cancellation of Time Delay
function.
C
Time Delay function cannot be set
after the programme starts.
Starting the programme
Close the door of your machine to
start it after selecting the programme
and auxiliary functions.
C
Your machine performs water
softening depending on the
hardness level of the supply
water. Washing time can change
while the programme is running
depending on the ambient
temperature where your machine
is installed, temperature of the
supply water and amount of the
dishes.
C
Pay attention not to open the door
of the machine when it is running.
There may be a rush of vapour
when you open the door of your
machine; be careful.
C
The machine will remain silent
in pause mode for some time
in order to remove the water in
the machine and on the dishes
completely and to have the water
softener cleaned, and then it will
resume running in drying mode.
Cancelling the programme
Open the door of the product Press
and hold the Programme Selection /
Programme Cancel keys for 3 seconds.
After the 3 - 2 - 1 countdown, 0:01
is displayed, close the door of the
product and wait for the draining
process complete. Draining is
completed in 2 minutes and the
machine gives an audible warning
when it is completed.
C
There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Salt indicator ( )
Please check the salt indicator on
the display to see whether there is
adequate amount of softening salt
in the dishwasher or not. You need
to refill the salt reservoir with salt
whenever salt indicator appears on
the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
Rinse Aid indicator ( )
Please check the rinse aid indicator
on the display to see whether there
is adequate amount of rinse aid in the
dishwasher or not. You need to refill
the rinse aid reservoir with rinse aid
whenever rinse aid indicator appears
on the display of your machine.
End of programme
C
When the programme you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine. This
audible signal will warn you with
certain intervals before it turns
off.
C
End of Programme indicator
will light up when the washing
programme is over (Depends on
the model).
28 EN
Hide quick links:
Advertisement
Table of Contents
