Installing An Internal Scsi Tape Backup Unit - Dell PowerEdge 1900 Systems Owner's Manual

16 Replace the bezel, if removed. See "Installing the Bezel" on page 47.
Figure 3-15. Installing and Removing the Half-Height Tape Backup Unit or Optical Drive
1 IDE or SCSI ribbon cable
(SATA cable not shown)
4 peripheral bay

Installing an Internal SCSI Tape Backup Unit

This subsection describes how to configure and install an internal SCSI tape backup unit.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
2 Remove the front bezel, if attached. See "Removing the Bezel" on page 46.
5
2 IDE or SCSI power cable
(SATA cable not shown)
5 half-height tape backup unit or
optical drive
1
2
3
4
3 release latch
Installing System Components
69