Nikon LS-2000 User Manual page 17

3. Setup
When installing the scanner on its side
Step 2—Remove the transport locking screws
Once the scanner is installed, slide the front cover open. Using a
coin, remove the transport locking screws from the adapter slot and
side panel and screw them into the holes provided on the rear panel.
The adapter slot contains a guard to prevent the transport screw
from falling into the scan mechanism when the transport screw is
removed. After removing the transport screw from the adapter slot
and screwing it into one of the holes on the rear of the scanner,
remove the guard and store it in a safe place.
Caution: Never turn the scanner on with the locking screws in
place. Turning the power on in these circumstances could damage
the scanner.
Note: Replace the locking screws and guard when transporting the
scanner (see the "LS-2000 Reference Manual").
Nikon
LS-2000 35 mm Film Scanner User's Guide
7