Maintenance; Replacing The Spool - Ryobi rlt4025 Operator's Manual

GB
F D E I

MAINTENANCE

REPLACING THE SPOOL

See fig.8
WARNING
Switch off and disconnect from the mains supply
before replacing, adjusting or cleaning your
trimmer. Be aware that the trimmer continues to
rotate for a few more seconds after it has been
switched off.
Press in both spool cover lock buttons, then remove
the spool cover.
Replace the spool with the new parts.
Place the spool, spool cover into position and Insert
the lines into the eyelets, and push in until the spool
cover lock buttons clicked into the designated cut outs
and the spool is secured in place.
CLEANING THE LINE TRIMMER
WARNING
Do not touch the cut-off blade on the safety
guard to avoid injury.
Regular cleaning and maintenance of your grass
trimmer will ensure efficiency and prolong the life of
the unit.
After each cutting operation, remove the grass and
soil from the spool, the whole trimmer and the safety
guard.
During operation, keep the air slots clean and free of
grass.
P NL S DK N FIN GR HU
English
CZ RU RO PL SLO HR TR EST LT
Only use a cloth soaked with hot water and a soft
brush to clean the line trimmer.
Do not spray or wet the appliance with water.
Do not use detergents or solvents as these could
damage the trimmer.
STORING THE LINE TRIMMER
Carry out general cleaning of the entire grass trimmer
and its parts to avoid the growing of mould.
Store it out of the reach of children, in safe and in a
dry place where the temperature is between 10 to 20
degree.
In order to reduce the needed storage space you can
shorten this line trimmer before storage.
WARNING:
When servicing, use only identical Ryobi
replacement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
13
LV SK BG