Parts Included - Haier HT Series User Manual

IN ST ALLA T ION GUIDE CON T.
LEV ELING YOUR RE FR IGE RAT OR
• All four corners of the cabinet must rest firmly on the floor
• The cabinet must sit level from side to side
• The cabinet must tilt slightly (1/4" or 6mm) from front to back for the
doors to seal properly
• Turn leveling legs counterclockwise to raise the cabinet
PROPER AIR C IRCULAT ION
• To ensure your refrigerator works at the maximum e ciency it was designed
for, you should install it in a location where there is proper air circulation,
plumbing and electrical connections. Your refrigerator is not design to opera-
te in temperatures below 55˚F (12˚C ) or above 95˚F (35˚C).
• Do not install your refrigerator in any location not properly insulated or
heated, e.g. garage, etc.
Keep out of direct sunlight and away from heating sources such as radiators,
heaters, and cooking appliances.
• The following are recommended clearances around the refrigerator:
Sides and Top...............1" (25 mm)
TOOLS NEEDED FOR INSTALLATION
DO NOT USE POWER TOOLS TO INSTALL DOOR HANDLES!
OVERTIGHTENING THE SCREWS COULD STRIP THE THREADS!
Phillips Screwdriver

PARTS INCLUDED

PARTS INCLUDED MAY DIFFER BASED ON UNIT PURCHASED
For models that come with a handle mounting
screw installed on the faces of the doors, the
parts included will consist of:
• 2 Handles
• 1 Front grille
• 4 Handle attachment screws
• Owner's manual
Back..................2" (50mm)
Putty Knife
Pliers
PAGE 6 • SET UP & USE
5/16 and 3/8 Wrenches or Adjustable Wrench
For models that don't come with a handle
mounting screw installed on the face of
the door, the parts included will consist of:
• 2 Handles
• 1 Front grille
• 2 Door face mounting screws
• 4 Door edge mounting screw
• 2 Handle cover/trim pieces
• Owner's manual
FRON T GRILLE