Pcb; Shelves; Defrost Control; Led - LG LTN16385PL Service Manual

3-4 FAN AND FAN MOTOR
1. Remove the freezer shelf.
2. Remove the freezer cover lamp, loosening screw fixed to
the ceiling of freezer. (See figure 13).
3. Remove the grill by pulling it out.
4. Remove the cover and remove the fan motor by loosening
two screws.
5. Remove the fan and pull the motor, base and guide fan.
(See figure 14).
Cover Fan
3-5 PCB DISASSEMBLY
1. Loosen the cover screws.
2. Remove the cover.
3. Disconnect all terminals.
4. Remove the PCB by pressing the hooks to the ends of
cover PCB.
5. Remove and replace the PCB main if necessary.
1
4
3-6. SHELVES DISASSEMBLY
In order to remove the
refrigerator shelves follow the
next instructions:
1. Take the shelf from the back.
2. Lift it from the bottom by
using the necessary strength
(figure 1).
Figure 13
Fan Motor
Guide fan
Fan
Cover Grill
Figure 14
2
3
5

Shelves

- 8 -
3. Release the locks (figure 2).
4. Slide it towards outside
(figure 3).
NOTE: Make sure that the shelf
is installed in the horizontal
manner. If not secured it can
cause the shelves to fall, which
will cause your stored food to
spill.

3-7 DEFROST CONTROL

The control assembly consists of a transmitter and a
malleable fuse, that with heat opens. The sensor function is
to control the temperature and finish automatically the
defrost, the transmitter is placed on one side of the metal part
of the evaporator. Malleable fuse is a safety device for
preventing overheating of the melt strength at the time of
working.
At a temperature of 77 ° C the fuse opens and stops emitting
heat resistance.
1. Remove the cover from the refrigerator, then remove the
fan grill.
2. Split the connector that is connected to the defrost control
assembly and replace if necessary.
COVER
GRILL
3-8 LED DISASSEMBLY
1. Remove the refrigerator
2. Remove the cover lamp by pressing the bottom to release
the hooks that hold it and then pull to remove.
3. Remove the PCB connector of the LED's.
4. Using a screwdriver, remove the PCB LED's and take it, if
necessary.
5. To reinstall, repeat the same steps but in order opposite.
1
4
Holder
Shelf
DEFROST CONTROL
shelves .
2 3