Table of Contents
Advertisement
CHAPTER 3.
Installation
Chapter3 describes how to install Ubigate iBG2006 for operation in a network facility.
Mounting the Ubigate iBG2006
This section describes how to prepare the Ubigate iBG2006 for operation
either as a tabletop or a rack-mounted unit.
Tabletop Installation
Place the Ubigate iBG2006 on a clean, flat, and stable surface with a
minimum available footprint of 18 by 19 inches. Allow sufficient room at the
front, rear, and side of the unit for interface cabling, power cord clearance, and
adequate ventilation.
Apply the rubber feet (4 included) to the bottom of the chassis prior to placing
the unit on a surface or when stacking several units on a surface.
© SAMSUNG Electronics Co., Ltd.
Ubigate iBG2006
Do not place any items that weigh more than 10 pounds (4.5 kilograms)
on top of the chassis, and do not stack routers on a tabletop.
Ubigate iBG2006 Installation Manual
3-1
Hide quick links:
Advertisement
Table of Contents
