3. TECHNICAL DESCRIPTION 3.1.11 Bluetooth Interface GT500 supports Bluetooth operation using ST’s STLC2593C Bluetooth module. A. General Description The Bluetooth interface utilizes the SPI interface for control signals going to and from the Bluetooth module. The SPI is also used for data transmissions.
3. TECHNICAL DESCRIPTION 3.1.12 MicroSD Interface card GT500 supports the MicroSD card interface as external memory card. MicroSD card has 4-data line, so GT500 uses 4-data lines. All control and data lines are connected to DB3200. Cause of the difference between DB3200 and MicroSD card, a level shifter should be added.
3. TECHNICAL DESCRIPTION 3.1.16 A-GPS GT500 supports A-GPS operation using Broadcom BCM4750 A-GPS module. The BCM4750 is a single chip, single die AGPS receiver that combines a high-performance RF front end with an adaptive baseband processor. The BCM4750’s small footprint and minimal parts count provide significant reductions in the design, layout, manufacturing, and testing resources required to integrate AGPS technology with mobile handsets and portable devices.
This section provides a description of the Video Telephony functions. Figure 3-3-8. Video Telephony Scheme Video Telephony Mode has same paths with Loud Speaker Mode. 3.3.8 Audio Main Component There are 4 components in GT500 schematic Diagram. Part Number marked on GT500 Schematic Diagram. ITEM PART NUMBER...
3. TECHNICAL DESCRIPTION 3.5.1 Fuel Gauge AB3100 supports the measurement of the current consumption/charging current in the GT500 with a fuel gauge block. By constantly integrating the current flowing into and out of the battery, the fuel gauge block is used to determine the remaining battery capacity.
WCDMA part, a GSM, and a RF front-end. Different from other general solutions, the RF front-end of GT500 consists of an antenna switch and an EDGE power amplifier module (PAM). The simplified block diagram is shown in Figure 3-7-1.
Page 174
The installation procedure of Download Configuration is described below: 1) You must select “Window Size” 1 ~ 4. ( Defualt is 4 ) 2) You must select “Chipset” U330 for GT500 / GT505. 3) You can select SW image to download by clicking “Add…” button.
Page 175
2) Connect your phone with Micro-USB cable. 3) Insert the Battery into phone. 4) In case of GT500/GT505, press Side-Up-Key. Keep pressing until step 6. 5) Press Power-Key. And then Downloading will be started. 6) Release both Side-Up-Key and Power-Key after start downloading in GT500 7) If Downloading has not started yet, Repeat procedure 1) ~ 6).
10. CALIBRATION 10. CALIBRATION 10.1 General Description This document describes the installation and software usage for the calibration of LG’s GSM/GPRS/EDGE/WCDMA Multimedia Mobile Phone. The calibration menu and it’s result is displayed in PC terminal by Mobile phone. 10.2 Environment 10.2.1 H/W Environment...