Changing The Dryer Vent Location - LG DLE4801W Owner's Manual

Changing the dryer vent location

WARNING
recommended safety procedures including the use of long
sleeved gloves and safety glasses.
result in property damage, Injury to person or death.
Your new dryer is shipped to vent to the rear.
It can also be configured to vent to the bottom or side (right-side
venting is not available on gas models).
An adapter kit, part number
from your LG retailer. This kit contains the necessary duct
components to change the dryer vent location.
exhaust duct.
Rear
Exhaust Duct
OPTION 1: SIDE VENTING
knockout for the desired vent opening (right-side venting is
not available on gas models). Press the adapter duct onto the
blower housing and secure to the base of the dryer as shown.
Adapter
Duct
, may be purchased
OPTION 2: BOTTOM VENTING
Retaining
Screw
INSTALLATION INSTRUCTIONS
sure that the male end of the elbow faces AWAY from the dryer.
Insert the elbow/duct assembly through the side opening and
press it onto the adapter duct. Secure in place with duct tape.
cm) to connect the remaining ductwork.
Attach cover plate to the back of the dryer with included screw.
Cover
Plate
Elbow
the base of the dryer as shown.
Adapter
Duct
the elbow faces down through hole in the bottom of the dryer.
Secure in place with duct tape.
Attach the cover plate to the back of the dryer with included
screw.
Cover
Plate
Elbow
15
1
1 / "
2
(3.8 cm)