Makita BTP131 Instruction Manual page 8

CAUTION:
Always set the arrow correctly to either mode mark.
•
If you operate the tool with the action mode
changing ring positioned halfway between the
mode marks, the tool may be damaged.
When turning the action mode changing ring, make
•
sure that the tool stops. If the ring does not easily
move, pull the switch trigger slightly to rotate the
spindle and then move the ring.
In the hammer drill mode or drill mode, the blowing
•
force or torque is not adjustable. In those modes,
the number on the LED display will be off.
Impact force grade
displayed on panel
Hard
Medium
Soft
012243
Maximum blows
BTP131 BTP141
3,200
3,200 Tightening when force
-1
-1
(min )
(min ) and speed are desired.
2,400
Tightening when a good
2,400
-1
-1
(min )
(min ) finishing is needed.
Tightening when excessive
tightening need to be avoided
1,200
1,200
because of potentially clogged
-1
-1
(min )
(min )
female screw and broken or
damaged screw head.
Changing the impact force
(impact driver mode " ")
2
3
4
1. Changed in three steps
2. Hard
3. Medium
4. Soft
5. Control button
012244
Application
8
1
Work
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.
5