Setting Up Tv Inputs - Mitsubishi Electric 151 Series Owner's Manual

12
1. Basic Setup and Operation

Setting Up TV Inputs

Channel Scan for Digital Channels
If you skip this step, the TV cannot receive digital
channels.
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV's
ANT input. Refer to page 21.
You must perform a channel scan to enable reception
of all available high-definition and standard-definition
digital channels. The channel scan will search for
channels available locally and save them to memory.
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
1.
Power on the TV.
2.
MENU and open the Initial > Channel menu.
Press
Start channel memorization from the Initial > Channel
menu.
3.
Press ENTER to enter the menu.
4.
Ant Air if connected to an
Select
over-the-air antenna. Select Ant
Cable for direct cable (service
without a cable box).
5.
Highlight Scan and press ENTER.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press CANCEL.
Use the Initial > Channel > Edit menu (page 48) for
additional channel options, such as adding or deleting
channels from memory.
Downloaded From TV-Manual.com Manuals
Setting Up Other Inputs
1.
Connect your devices to the TV, making note of
which TV input jack is used for each device. See
"TV Connections," page 16, for recommendations.
2.
Power on the devices to ensure detection.
3.
Power on the TV.
The TV will display the New Device Found screen
for each new connection it detects Learn more
about Auto Input/Auto Output Sensing on the
opposite page.
4.
Select the device type if the device is not recog-
nized automatically.
5.
153 and 249 Series.
mand IR "learning" after selecting the device type
or at a later time when convenient. To perform now,
highlight NetCommand and press ENTER. See
"Initial NetCommand Setup," page 57 or "Setting Up
A/V Receiver Control," page 62.
Important Note for NetCommand IR Users
153 and 249 Series. Be sure to select the correct
device type here. Although you can change the
device type later in the Inputs > Name menu, any
"learned" NetCommand IR codes will be erased
when you make the change.
6.
BACK to close the New Device Found screen.
Press
The TV will then display the New Device Found
screen for the next connection it finds.
Sample New Device
Found screen.
You can perform NetCom-