Mount The Camera - D-Link DCS-5009l Quick Install Manual

Please refer to the steps below to assist you with mounting the camera.
1. Place the mounting bracket where you want to
position the camera and use a pencil to mark
the holes.
2. Depending on the material of the wall or ceiling,
use a 6mm drill bit to drill two holes where you
marked. If the wall is made out of concrete, after
drilling the holes, insert the plastic anchors and
el.
then insert the screws.
3. The power and Ethernet cables can be
concealed behind the mounting bracket. Run
the cables through the back of the mounting
bracket, securing them with the built-in
guides. Be sure to leave enough cable length
protruding from the top to allow connection to
the camera.
4. Fasten the mounting bracket to the wall using
the screws provided.
5. Using the supplied thumbscrew, fasten the
camera to the mounting bracket. Connect the
power and Ethernet cables to the camera.
6. Adjust the angle of the arm on the mounting
bracket as required. Tighten the thumbscrew to
lock the arm in place.

Mount the Camera

We suggest that you configure the camera before mounting.
Do not overtighten the screws as this may crack the bracket.
2
7
1
3
4
5
6