D2846 SERVICE MANUAL US Model Canadian Model AEP Model Chassis No. SCC-L04G-A CHASSIS SPECIFICATIONS COLOR GRAPHIC DISPLAY...
Page 2
D2846 SAFETY CHECK-OUT (US Model only) After correcting the original service problem, perform the fol- LEAKAGE TEST lowing safety checks before releasing the set to the customer: The AC leakage from any exposed metal part to earth ground 1. Check the area of your repair for unsoldered or poorly-sol- and from all exposed metal parts to any exposed metal part dered connections.
D2846 SECTION 2 DISASSEMBLY 2-1. CABINET REMOVAL Four screws (+ BVTP 4 x 16) Screw cover Four screws (+ BVTT 4 x 8) Two claws Top cover Screw cover Cabinet Four screws (+ BVTT 4 x 8) Video shield 2-2. D BOARD REMOVAL...
D2846 2-3. G BOARD REMOVAL Two screws (+BVTP 3 x 10) Screw (+ BVTT 4 x 8) G shield Two screws (+ BVTT 4 x 8) G board Three hooks Open the G block in the direction Two printed circuit board holders of the arrow .
D2846 2-7. SERVICE POSITION CAUTION : SHORT D,G boards Rear shield If the claw is hooked, opening and closing the board is impossible. Do not try to do it by force. D board (Refer to 2-2.) A board (Refer to 2-4.)
D2846 2-9. PICTURE TUBE REMOVAL Open the D block (Refer 2-2.) Four screws (+ BVTT 4 x 8) Three connectors GND (DY) 6P (DY) A board 10P (DY) Anode cap Open the G block (Refer 2-3.) Neck assy Deflection yoke Picture tube •...
D2846 SECTION 3 SAFETY RELATED ADJUSTMENT When replacing or repairing the shown below table, the a) HV Regulator Circuit Check following operational checks must be performed as a 1) Confirm that the voltage of the pin 2 of CN901 on D safety precaution against X-rays emissions from the unit.
D2846 SECTION 4 ADJUSTMENTS • Landing Rough Adjustment (µm) <Specifications> Adjust so that the green is within 0 ± 3 0 ± 7.5 0 ± 3 1. Enter the full white signal. (or the full black dots signal). the specification given right.
Page 20
D2846 Connect the communication cable of the computer to the connector located on the D board on the monitor. Run the service software and then follow the instruction. 1-690-391-21 A-1500-819-A 3-702-691-01 Interface Unit Connector Attachment IBM AT Computer To BUS CONNECTOR...
D2846 D2846 D2846 SECTION 5 DIAGRAMS 5-1. BLOCK DIAGRAMS (POWER SW) CN520 CN504 CN512 (U-COM,DEFLECTION) LLC_RB CN891 POWER LLC_RT S891 H CONV HTR_SW LLC_LB AC L IN POWER IC012 V CONV STBY 8V LLC_LT AC L OUT LLC_LB CN511 V CLK C.SYNC_1...
Page 22
D2846 D2846 D2846 TO FBT FV1 FV2 HV IC401 IC402 IC403 RGB SWITCH RGB PRE-AMP RGB OUT V901 PICTURE TUBE CN402 Q101 R IN 2 R_IN2 R_OUT R_IN R_OUT R_IN R_OUT G IN 2 G_IN2 G_IN G_OUT BUFFER Q201 B IN 2...
D2846 D2846 D2846 5-3. CIRCUIT BOARDS LOCATION Note: The components identified by shading and mark 5-2. FRAME SCHEMATIC DIAGRAM ¡ are critical for safety. Replace only with part number specified. Note: Les composants identifiés per un tramé et une CONNECTOR PANEL R IN 1 ¡...
Page 24
D2846 D2846 D2846 — D BOARD (Conductor Side) — • D BOARD SEMICONDUCTOR LOCATION — D BOARD (Component Side) — D010 E–2 µ-COM, D011 E–2 Conductor Component DEFLECTION Side Side D012 E–2 D013 E–2 IC001 E–2 D014 E–2 IC002 E–3 D015 E–2...
Page 25
(1) Schematic Diagram of D Board ROTATION+ TO L BOARD TO L BOARD ROTATION- CN5002 CN5001 CN520 CN512 CN509 :S-MICRO :S-MICRO :S-MICRO • D BOARD VOLTAGE LIST D027 D028 D029 R1022 D026 0 :CHIP MA153 MA153 MA153 MA153 +15V µ-COM, CN511 -15V Ref.
(2) Schematic Diagrams of G, GA, H, J, L and U3 Boards (CONNECTION BOARD) STBY+5V (POWER SENSOR) CN891 +15V C811 • GA BOARD Q7504 2SA1037AK Q801 TO D BOARD AC L OUT CN7501 CN3001 VOLTAGE LIST 2SC3311A CN801 R7509 Q802 CN501 B-TO-B LED DRIVE...
Page 27
D2846 D2846 D2846 (ga) V.STAT, H.STAT, LLC, POWER SUPPLY POWER SENSOR USER CONTROL GEO MAGNETIC SENSOR — G BOARD — — L BOARD (Conductor Side) — — L BOARD (Component Side) — — H BOARD — — GA BOARD —...
D2846 SECTION 6 EXPLODED VIEWS • Items with no part number and no • Items marked " * " are not stocked since The components identified by shading description are not stocked because they they are seldom required for routine and mark are critical for safety.
D2846 6-2. PICTURE TUBE Les composants identifiés per un tramé The components identified by shading ¡ et une marque sont critiques pour la 7-685-663-71 +BVTP 4X16 and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified.
D2846 SECTION 7 Les composants identifiés per un tramé The components identified by shading et une marque sont critiques pour la and mark are critical for safety. ELECTRICAL PARTS LIST sécurité. Ne les remplacer que par une Replace only with part number specified.
Page 35
D2846 The components identified by shading Les composants identifiés per un tramé and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 36
D2846 Les composants identifiés per un tramé The components identified by shading et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 37
D2846 The components identified by shading Les composants identifiés per un tramé and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 38
D2846 Les composants identifiés per un tramé The components identified by shading (a)(ga)(g) et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 39
D2846 The components identified by shading Les composants identifiés per un tramé and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 40
D2846 Les composants identifiés per un tramé The components identified by shading (g)(d) et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 41
D2846 The components identified by shading Les composants identifiés per un tramé and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 42
D2846 Les composants identifiés per un tramé The components identified by shading et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 43
D2846 The components identified by shading Les composants identifiés per un tramé and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 44
D2846 Les composants identifiés per un tramé The components identified by shading et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 45
D2846 The components identified by shading Les composants identifiés per un tramé and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 46
D2846 Les composants identifiés per un tramé The components identified by shading et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 47
D2846 The components identified by shading Les composants identifiés per un tramé (d)(h) and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 48
D2846 Les composants identifiés per un tramé The components identified by shading (h)(u3)(j)(l) et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 49
D2846 The components identified by shading Les composants identifiés per un tramé and mark are critical for safety. et une marque sont critiques pour la sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.
Page 50
D2846 Les composants identifiés per un tramé The components identified by shading et une marque sont critiques pour la and mark are critical for safety. sécurité. Ne les remplacer que par une Replace only with part number specified. piéce portant le numéro spécifié.