GoPro HERO4 SILVER User Manual page 23

/ Multi-Shot Mode
CAPTURING BURST PHOTOS
1. Select Burst mode:
a. Swipe left to display the camera modes, and then tap the
upper right icon (Multi-Shot mode).
b. Swipe up to open the settings menu.
c. Tap Mode, and then tap Burst.
d. Swipe down to close the settings menu. The Burst icon [
appears in the upper left on your camera displays.
2. Press the Shutter/Select button [
flash and the camera beeps multiple times.
See Rate in this section for options available for Burst photos.
44
]
]. The camera status lights
CAPTURING TIME LAPSE OR NIGHT LAPSE PHOTOS
1. Select the desired capture mode (Time Lapse or Night Lapse):
a. Swipe left to display the camera modes, and then tap the
upper right icon (Multi-Shot mode).
b. Swipe up to open the settings menu.
c. Tap Mode, and then tap the desired capture mode
(Time Lapse or Night Lapse).
d. Swipe down to close the settings menu. The icon for the
selected capture mode appears in the upper left on your
camera displays.
2. Press the Shutter/Select button [
countdown and the camera status lights flash each time a photo
is captured.
3. To stop capturing, press Shutter/Select button [
status lights flash three times and the camera beeps three times.
PRO TIP: When the camera is off and QuikCapture is enabled, you
can turn the camera on and immediately begin capturing Time Lapse
photos just by pressing and holding the Shutter/Select button [
Press again to stop recording and power off the camera. For details,
see Setup Mode.
/ Multi-Shot Mode
]. The camera initiates
]. The camera
].
45