Linear Amplifier Connections; D Connecting The Ic-Pw1/Ic-Pw1Euro; D Connecting A Non-Icom Linear Amplifier - Icom ic-7300 Full Manual

2
INSTALLATION AND CONNECTIONS

Linear amplifier connections

D Connecting the IC-PW1/IC-PW1EURO

See the illustration below to connect the optional IC-PW1 or IC-PW1EURO
Refer to the amplifier's instruction manual for operation.
To an
antenna
[ACC-1]
[ANT]
IC-PW1/IC-PW1EURO
AC outlet
Non-European versions: 100~120/200~240 V
European version:

D Connecting a non-Icom linear amplifier

See the illustration below to connect a non-Icom linear amplifier.
To an antenna
Non-Icom linear amplifier
RF OUT RF IN
R WARNING!
• The maximum signal level of the [SEND] jack is 16 V/0.5 A DC with the initial setting, and 250 V/ 200 mA with the "MOSFET"
setting. Use an external unit if your non-Icom linear amplifier requires a control voltage and/or current greater than specified.
• The ALC input level must be in the range 0 to –4 V. The transceiver does not accept a positive voltage. Non-matched ALC
and RF power settings could overheat or damage the linear amplifier.
• When using a linear amplifier such as the IC-PW1 or IC-PW1EURO, set the RF POWER in the Multi-function menu to keep
the ALC meter in the red zone.
LSee page 3-10 for details on the RF POWER
LSee page 3-11 for details on the ALC zone.
Remote control cable
ACC cable
[REMOTE]
[INPUT 1]
EXCITER
1 1&2
230 V
ALC
SEND
hf/50 mhz all band 1 kw linear amplifier
OPC-599 conversion cable
Coaxial cable
GND
[ANT]
GND
GND
[ANT]
2-6
7-pin side
[ACC]
[REMOTE]
IC-7300
[ALC] [SEND]
IC-7300
.