Netopia 3346(EU Quick Start Manual

B B ™
ROADBAND WITHOUT OUNDARIES
®
Netopia 4-Port ADSL Router
M M M M o o o o d d d d e e e e l l l l s s s s : : : : Netopia® 3346(EU, DE)-ENT / 3356(EU, DE)-ENT ADSL Routers – All Models
Checklist
Unpack your Gateway, check your package contents, and decide on a location :
• Place the Gateway in a spot that is easily accessible for you. You can lay it flat or
mount on the wall.
• Keep the cables away from other electrical devices that may interfere with the oper-
ation of your Gateway.
Netopia Router
-or-
International
Power Supply
Lavender RJ-11
Telephone Cable
If you don't have everything, contact your supplier immediately.
Set up your Router
1.
After unpacking your Netopia Router shipping carton, decide where you want
to locate the Router.
You should install the Router near your PC or another location that permits easy access

Quickstart Guide

and visibility. You can lay the Netopia Router flat or mount it on a wall. Make sure any
Ethernet cables are kept away from power cords, fluorescent lighting fixtures, and
other sources of electrical interference. Put the Router in a location where air can circu-
late freely around it.
2.
Connect the power transformer to the power jack on the Router back panel.
Plug the power transformer into an appropriate electrical outlet.
Turn on the power with the power switch. The
3.
Connect the Router to the wall jack that supports your DSL service.
Insert one end of the lavender telephone cable in the DSL port on the Router back
panel until you feel it lock. Insert the other end of the telephone cable into the tele-
phone jack connected to your ADSL service. The
blink for up to two minutes and then come on solid green.
Rear View
CD & Quickstart
Guide
North American
4.
Connect the Router to create your Ethernet local area network (LAN.)
Yellow RJ-45
Ethernet Cable
Connect the yellow Ethernet cable to your first PC and to the Router.
The LAN
your Ethernet cable.
Connect each computer or other device to a switch port on the back of the Router with
an Ethernet cable (maximum length 100 meters). If you need more than four ports, con-
nect a hub or switch to the Router using a standard Ethernet cable.
1
Power light should come on solid green.
DSL SYNC indicator light should
10/100BT LAN
DSL
Power Supply
4 3 LAN 2 1 Power Off / On
DSL
4
3
indicator light should come on solid green for the port where you connected
When all of your connections are made, the status LEDs on the front of your Netopia Router
will light, according to the following diagram:
Front View
Configure Your PC for Dynamic Addressing
The following instructions assume that you want to use the automatic configuration and
address sharing features of the Router to provide IP information to devices on your local
Ethernet network.
1.
Configure your computer to use an IP address on the same TCP/IP network as
the Netopia Router.
• Windows 95/98 or Windows ME:
• Right-Click on the N N N N e e e e t t t t w w w w o o o o r r r r k k k k N N N N e e e e i i i i g g g g h h h h b b b b o o o o r r r r h h h h o o o o o o o o d d d d icon on your Windows desktop and
select P P P P r r r r o o o o p p p p e e e e r r r r t t t t i i i i e e e e s s s s from the pull-down menu.
• In the list of network components, highlight the entry that says
2
" T T T T C C C C P P P P / / / / I I I I P P P P ( ( ( ( [ [ [ [ y y y y o o o o u u u u r r r r E E E E t t t t h h h h e e e e r r r r n n n n e e e e t t t t c c c c a a a a r r r r d d d d h h h h e e e e r r r r e e e e ] ] ] ] ) ) ) ) ".
• Click the P P P P r r r r o o o o p p p p e e e e r r r r t t t t i i i i e e e e s s s s button.
• Click the O O O O b b b b t t t t a a a a i i i i n n n n a a a a n n n n I I I I P P P P a a a a d d d d d d d d r r r r e e e e s s s s s s s s a a a a u u u u t t t t o o o o m m m m a a a a t t t t i i i i c c c c a a a a l l l l l l l l y y y y radio button. Click the DNS Con-
Power Switch
figuration tab. Click the D D D D i i i i s s s s a a a a b b b b l l l l e e e e D D D D N N N N S S S S radio button. Click the Gateway tab and remove
any installed Gateways. Click the O O O O K K K K button twice. When prompted, restart your PC.
• Proceed to the next section
• Windows 2000 and XP
• Right-Click on the M M M M y y y y N N N N e e e e t t t t w w w w o o o o r r r r k k k k P P P P l l l l a a a a c c c c e e e e s s s s icon on your Windows desktop and select
P P P P r r r r o o o o p p p p e e e e r r r r t t t t i i i i e e e e s s s s .
• Select your L L L L o o o o c c c c a a a a l l l l A A A A r r r r e e e e a a a a C C C C o o o o n n n n n n n n e e e e c c c c t t t t i i i i o o o o n n n n .
• Right click on your L L L L o o o o c c c c a a a a l l l l A A A A r r r r e e e e a a a a C C C C o o o o n n n n n n n n e e e e c c c c t t t t i i i i o o o o n n n n and select P P P P r r r r o o o o p p p p e e e e r r r r t t t t i i i i e e e e s s s s .
• Select I I I I n n n n t t t t e e e e r r r r n n n n e e e e t t t t P P P P r r r r o o o o t t t t o o o o c c c c o o o o l l l l [ [ [ [ T T T T C C C C P P P P / / / / I I I I P P P P ] ] ] ] .
• Click the P P P P r r r r o o o o p p p p e e e e r r r r t t t t i i i i e e e e s s s s button.
• Click the O O O O b b b b t t t t a a a a i i i i n n n n I I I I P P P P a a a a d d d d d d d d r r r r e e e e s s s s s s s s a a a a u u u u t t t t o o o o m m m m a a a a t t t t i i i i c c c c a a a a l l l l l l l l y y y y radio button and the O O O O b b b b t t t t a a a a i i i i n n n n D D D D N N N N S S S S
s s s s e e e e r r r r v v v v e e e e r r r r a a a a d d d d d d d d r r r r e e e e s s s s s s s s a a a a u u u u t t t t o o o o m m m m a a a a t t t t i i i i c c c c a a a a l l l l l l l l y y y y radio button. Click the O O O O K K K K button.
• Proceed to the next section
2
Power - Green when power is applied
DSL SYNC -
Flashes green when training
Solid green when trained
Flashes green for DSL traffic
LAN 1, 2, 3, 4 -
Solid green when connected
to each port on the LAN.
Flash green when there is
activity on each port.
"Configure Your Netopia Router" .
"Configure Your Netopia Router" .
3