Breville HotCup VKJ367 Manual page 8

BEFORE USING YOUR HOTCUP
• Remove your HotCup
promotional material and position your HotCup
away from the edge.
• Follow the instructions below and discard the first full tank of water. This will remove
any residues that may remain from the manufacturing process.
• Fit the filter funnel and the BRITA
—see pages 6 and 7.
USING YOUR HOTCUP
Always position your HotCup
accidentally operated, especially by children. As you use your HotCup
portion of the water boiled will be transferred back to the water reservoir. This will
mean the water reservoir may become hot. Always use care when handling your
HotCup .
™
1. Press the lid flap release button to open the lid flap.
2. Fill the filter funnel from your cold tap up to the MAX mark on the filter funnel. Allow
the water to filter through into the water chamber. Repeat until the water level in the
chamber is no higher than the MAX marking on the water chamber.
3. Close the lid and press the stop button. This will make sure that your HotCup
not immediately start a boil cycle when you place it onto the power base.
4. Connect your HotCup
5. Place a suitable cup or container with a tea bag, coffee, sugar, etc. below the
dispensing nozzle. Never operate your HotCup
placed below the dispensing nozzle. Adjust the dispensing control to the required
setting. The control adjusts the quantity of boiling water dispensed by your HotCup
For smaller cups like teacups, set the control towards the
like coffee mugs, set the control towards the
setting to use, it's best to use a lower setting until you gain experience using your
HotCup ™ .
6. Press the start button. The body will light up blue and your HotCup
7. The selected quantity of boiling water will be dispensed into the cup. Your HotCup
now ready to use again. If, after just having boiled, the start button doesn't operate,
simply wait a few seconds before trying it again.
STOPPING YOUR HOTCUP
If you have started the boil procedure and then decide you want to stop your HotCup
any reason, simply press the stop button. You can also stop water that is being dispensed
by pressing the stop button. The boiled water will be safely transferred back into the water
reservoir.
8
FOR THE FIRST TIME
™
carefully from the box. Remove any packaging and
™
MAXTRA
®
™
in such a way that the start button cannot be
™
to a mains supply socket.
™
™
on a dry, level, secure work surface
™
water filter and set the BRITA
®
without a cup or suitable container
™
setting; for larger cups
setting. If you are not sure which
Memo
®
, a certain
™
will
™
.
™
will start to boil.
™
is
™
for
™