Safety Instructions; Proper Disposal; Installation Surface; Scope Of Delivery - Bosch was20160uc Installation Instructions Manual

y

Safety instructions

– The washing machine is heavy - lift with caution.
– Frozen hoses can tear/burst. Do not install the washing machine outdoors or in an area exposed
to freezing conditions.
– These installation instructions are intended for use by qualified installers. In addition to these
instructions, if installing the washing machine:
In the United States comply with the National Electric Code, ANSI/NFPA70 - latest edition/State
and municipal and/or local regulations.
In Canada comply with the Canadian Electric Code C22.1 - latest edition/provincial and municipal
and/or local regulations.
– If the washing machine is located in a room which will be exposed to temperatures below freezing,
or if it is located in a cabin that is being shut down for the winter, any residual water in the pump
or water inlet hose(s) must be drained.
– Take care not to damage the washing machine. Do not hold on to protruding parts (e.g. door)
when lifting.
– In addition to the safety information listed here, the local water end electricity supplier may have
special requirements.
– If in doubt, have the appliance connected by an authorized technician.

Proper disposal

– All packaging materials are non-polluting and recyclable. Please contribute to a better environment
by disposing of packaging materials in environmentally friendly manner. Please ask your dealer or
local authority about the best means of disposal.
Old appliances are not worthless rubbish. Valueable raw materials can be reclaimed from
environmentally friendly recycling.

Installation surface

– Stability is important to that the machine does not "walk"!
– The installation surface must be solid and level.
– Soft floors/floor coverings are not suitable.
For installation on a base
– Fasten the washing machine feet with retaining tabs* (*Order no. WMZ 2200, WX 9756).
For installation on a wooden joist floor
– Install the washing machine in a corner if at all possible.
– Screw a waterproof wooden plate (min. 1.18 in. thick) on the floor.
– Fasten the washing machine feet with retaining tabs* (*Order no., see above).
Under-counter/closet installation of the machine
Under-counter / in-cabinet installation before connecting to power supply.
Installation in kitchen cabinets (under-counter or in-cabinet)
– Cubicle width of 23.62 in. is required.
– Only install the washing machine under a continuous counter top which is securely fastened
to the neighboring cabinets.
– If installing the washer in a closet, observe the minimum distances:
Side: 0 in., rear: 1.97 in., top: 0 in., front: 2.76 in.

Scope of delivery

Standard
Covers with
hose holders
Additionally needed depending on connection
– 1 hose clamp Ø 0.94 in.-1.57 in. (commercially available) for connectiong to siphon
Page 4; Water connection.
Useful tool
– Level for alignment.

Hose and cable lengths

Left-side connection
Note: When using the hose holder, possible hose lengths are reduced!
Available commercially or from customer service:
– Longer supply hose (approx. 86.61 in.), for standard model.
1
Moisture in the drum is
due to end inspection.
Power cord
Drainage hose
Wrench
Elbow
for fixing the waste
water hose
or Right-side connection
51 in. 47 in.
41 in. 28 in.
37 in. 55 in.
Water supply hoses
2