Hardware Overview - D-Link DIR-890L Quick Install Manual

Hardware Overview

1
SS USB LED
2 USB LED
3
5G LED
4 2.4G LED
5 Internet LED
6 Power LED
7 USB 3.0 Port
8
USB 2.0 Port
9
Reset Button
10 WPS Button
LAN Ports
11
(1-4)
12 Internet Port
13
Power Button Press to power the router on and off.
14 Power Port
4
1 2 3
7 8 9 10
A solid white light indicates a USB 3.0 device is connected.
A solid white light indicates a USB 2.0 device is connected.
A solid white light indicates the 5GHz wireless function is working properly.
During the WPS process, this light will blink quickly.
A solid white light indicates the 2.4GHz wireless function is working properly.
During the WPS process, this light will blink quickly.
A solid white light indicates a connection to the Internet port. If the LED is
orange, the connection is good but the router cannot connect to the Internet.
A solid white light indicates a proper connection to the power supply. The light
will be solid orange during boot-up.
Connect a USB flash drive to share content throughout your network. Port
supports USB 3.0 and USB 2.0 devices.
Connect a USB flash drive to share content throughout your network. Port
supports USB 2.0 devices.
Press and hold the reset button with a paper clip for ten seconds to reset the
router to the factory default settings.
Press to start the WPS process. The 2.4G or 5G LED will blink fast.
Connect Ethernet devices such as computers, switches, and game consoles.
Connect a broadband modem to this port using an Ethernet cable.
Connect the supplied power adapter.
4 5
11
12 13 14
6