Table of Contents
Advertisement
134
If Something Goes Wrong
Develop good computing habits
❖
Do not guess
necessary to run an installation utility first
connecting a new hardware item to the computer. If the
device is connected first, it may be very difficult to
complete the installation successfully. Always carefully
follow the installation instructions that accompany the
hardware or software.
❖
Restart the Windows operating system. Always restart
the Windows operating system after each installation,
even if the installation utility does not prompt you to do
so. This will ensure that the installation is completed,
and will clean up anything that the installation utility left
behind.
❖
Do one installation at a time. If you have several new
items to add to your computer system, install just one at
a time, creating restore points immediately before each
successive installation. This will make it much easier to
determine the origin of any new problems. For best
results, follow this sequence:
1
2
3
4
5
6
USB Sleep and Charge is not working.
USB Sleep and Charge may be disabled. Open the TOSHIBA
Sleep and Charge utility to check if the feature is disabled
and to enable it if necessary.
❖
Make sure that the device you want to charge is
connected to a port that supports the USB Sleep and
Charge function. Ports that support this feature are
identified with the ( ) icon.
-
follow directions carefully! It is often
Back up critical data.
Create a restore point.
Install one item of hardware or software.
Restart the Windows operating system.
Use the new hardware or software for a while, noting
any new problems. Make sure that your critical
applications (email, business applications, etc.) are
working correctly, and verify that important devices
are still functioning.
For each additional hardware or software item,
repeat these steps, starting at step
critical data has changed, or starting at step
critical data has changed.
-
before
1
if any of your
2
if no
Advertisement
Table of Contents
