Adjusting The Camera Position - JVC vn-t216vpru Quick Manual

■Waterproofing
Filling the duct hole with waterproof seal material (GE silicon) to
prevent water from entering.
Note
Before you fill the silicon gel in the location as figure below,

please insert the cables to proper location.
Correctly waterproof all the cables using waterproof tape

adhesive.

Adjusting the Camera Position

The dome camera has three axes for positioning the camera. While monitoring the picture on the
monitor, adjust the camera position as follows:



Pan Adjustment (A) For Wall Mount and Tilted Ceilings Rotate the lens base
(maximum360°) until you are satisfied with the field of view.
Horizontal Rotation (B) Rotate 3D assembly in the base. Do not turn assembly more than
360°as this assembly may cause the internal cables to twist and disconnect or break.
Tilt Adjustment (C) After loosening the thumbnuts, position the camera as desired, then
finger –tighten the thumbnuts to set the position.
Do not turn the lens more than 360° as this may cause internal cables to
Caution
disconnect or break.
Caution Retighten the locking screws to prevent loss of adjustment.
6
D
E