How To Connect; How To Order - Philips 7603 series Service Manual

• If both ComPair and SearchMan (Electronic Service Manual) are installed, all the schematics and the PWBs of the set
are available by clicking on the appropriate hyperlink.
Example: Measure the DC-voltage on capacitor C2568 (Schematic/Panel) at the Monocarrier.
Click on the 'Panel' hyperlink to automatically show the PWB with a highlighted capacitor C2568.
Click on the 'Schematic' hyperlink to automatically show the position of the highlighted capacitor.

How To Connect

1. First install the ComPair Browser software (see the Quick Reference Card for installation instructions).
2. Connect the RS232 interface cable between a free serial (COM) port of your PC and the PC connector (marked with
'PC') of the ComPair interface.
3. Connect the AC power adapter to the supply connector (marked with 'POWER 9V DC') on the compare interface.
4. Switch the ComPair interface OFF.
5. Switch the television set OFF, remove the AC power.
6. Connect the ComPair interface cable between the connector on the rear side of the ComPair interface (marked with 'I
C') and the ComPair connector on the mono carrier (see Hardware alignments suffix D).
7. Plug the AC power adapter in the AC power outlet and switch on the interface. The green and red LEDs light up together.
The red LED extinguishes after approx. 1 second while the green LED remains lit.
8. Start the ComPair program and read the introduction chapter.

How To Order

ComPair order codes:
• Starter kit ComPair + SearchMan software + compare interface (excluding transformer): 4822 727 21629
• ComPair interface (excluding transformer): 4822 727 21631
• Starter kit ComPair software (registration version): 4822 727 21634
• Starter kit SearchMan software: 4822 727 21635
• ComPair CD (update): 4822 727 21637
• SearchMan CD (update): 4822 727 21638
• ComPair interface cable: 3122 785 90004
2