Connect The Cables - Axis Q1910 Installation Manual

Page 10
10. Loosen the bracket adjustment screw to aim the camera to the point of interest. See
video stream,
on page 15 for information on how to view the video stream.

Connect the cables

1. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.
2. Optionally connect external input/output devices. See page 18 for information on the terminal
connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect the camera to the network using a shielded network cable.
5. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet, Class 3). If available, this is automatically detected when the
network cable is connected.
• Connect an external power adapter to the power connector block, see
page 18 for wiring information.
6. Check that the indicator LEDs indicate the correct conditions. See the table on page 20 for
further details.
AXIS Q1910/-E/AXIS Q1921/-E Installation Guide
Access the
Unit connectors,
on