Specifications - Makita JS1660 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
-1
)
Overall length
Net weight
Safety class
equipment and
JS1660
2
1.6 mm (16 ga.)
2
1.2 mm (18 ga.)
2
0.8 mm (22 ga.)
2
2.5 mm (13 ga.)
4,500
304 mm
1.4 kg
END201-5
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting sheet metal
Vibration emission (a
its
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENE037-1
WARNING:
The vibration emission during actual use of the
•
ENF002-1
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
---
/II
) : 84 dB(A)
pA
) : 95 dB(A)
WA
Wear ear protection
) : 8.0 m/s
h
2
JS1670
1.0 mm (20 ga.)
0.7 mm (23 ga.)
0.5 mm (26 ga.)
2.5 mm (13 ga.)
30 mm
4,500
306 mm
1.4 kg
/II
ENG102-3
ENG218-2
2
ENG901-1