Commissioning and opera-
tion
Always work with an inserted car-
tridge filter - during wet as well as
dry vacuum cleaning!
Attaching the Accessories
Illustration
Remove the appliance head and take
accessories out of the container.
Illustration
Turn the container, press in the swivel
casters in the openings at the base of
the container till the end-point.
Illustration
Put the appliance head onto the con-
tainer and lock it.
Illustration
Connect accessories.
Illustration
Connect the mains plug and turn on the
appliance.
Dry vacuum cleaning
Work only with a dry cartridge filter!
Caution: Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).
Vacuum cleaning of hard surfaces:
Illustration
Insert the hard surface inlay into the floor
nozzle. The bristles should point towards
the front.
Vacuum cleaning of carpets:
Illustration
Work without the hard surface insert.
Wet vacuum cleaning
Use the hard-surface insert when wet
vacuuming.
Caution
Immediately switch the appliance off or pull
the power plug if foam forms or liquids es-
cape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
Finish operation
Illustration
Turn off the appliance and disconnect
the mains plug.
Empty the container
Illustration
Remove the appliance head and empty
the reservoir.
Storing the appliance
Illustration
Stow away the mains cable and acces-
sory at the machine. Store the appli-
ance in a dry room.
Maintenance and care
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
Caution
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
If required, rinse the container and ac-
cessories with water properly and dry
them before reuse.
Illustration
Only clean the cartridge filter under run-
ning water; do not wipe or brush. Let it
dry completely prior to installation.
7
English