Quick Start
To attach the MultiSync
instructions:
1. Turn off the power to your computer.
2. For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable
to the connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync LCD
(Figure B.1). Attach the 15-pin mini D-SUB end of the appropriate signal cable to the
MultiSync LCD
400V
NOTE: To obtain the MultiSync LCD
call NEC Technologies at (800) 820-1230.
3. Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on
the back of the monitor (Figure C1).
NOTE: Incorrect cable connections may result in irregular operation, damage
display quality/components of LCD module and/or shorten the module's life.
4. Connect one end of the power cord to the MultiSync LCD Series monitor and the other
end to the power outlet (Figure D.1).
5. Turn on the monitor (Figure E.1) and the computer.
6. To complete the setup of your MultiSync LCD monitor, use the following OSM
• Auto Adjust Contrast
• Auto Adjust
Refer to the Controls section of this User's Manual for a full description of these OSM controls.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
Figure A.1
78133331
LCD monitor to your system, follow these
®
400V
Macintosh cable adapter (Figure B.1). Tighten all screws.
Macintosh cable adapter,
400V
15-pin
mini D-SUB
Mac Adapter
(not included)
2
4
™
Macintosh cable adapter to the computer
Figure B.1
9/25/98, 12:46 PM
controls:
™
15-pin
mini
D-SUB